thomas
Well-Known Member
- Joined
- Dec 16, 2011
- Messages
- 293
- Reaction score
- 23
I have some problems with my Telemega V1.0 firmware 1.64,
Regardless of the orientation Up, down or horizontal my Telemega boots always in the idle mode.
Also if I reboot it over the radio.
The next problem is, I can not communicate with it over usb, neither on Windows or on Linux.
I have tried to load the bootloader mode to recover from a bad firmware flash but even then I can not see the device. Maybe I can pair program it, I need to solder the 4pin mico match connector to the debug port for that, right?
I can configure it over the radio with Linux, Windows and Android.
I had a look at the acceleration values in idle mode and it seems they are all negative -5m/s^2 antenna up, -25 antenna down, -15 horizontal
I tired to send this on the altusmetrum mailing list but somhow my email gets rejected.
Regardless of the orientation Up, down or horizontal my Telemega boots always in the idle mode.
Also if I reboot it over the radio.
The next problem is, I can not communicate with it over usb, neither on Windows or on Linux.
I have tried to load the bootloader mode to recover from a bad firmware flash but even then I can not see the device. Maybe I can pair program it, I need to solder the 4pin mico match connector to the debug port for that, right?
I can configure it over the radio with Linux, Windows and Android.
I had a look at the acceleration values in idle mode and it seems they are all negative -5m/s^2 antenna up, -25 antenna down, -15 horizontal
I tired to send this on the altusmetrum mailing list but somhow my email gets rejected.