dhkaiser
Well-Known Member
- Joined
- Nov 27, 2014
- Messages
- 413
- Reaction score
- 11
Picked up a DX3 SD last weekend and while testing parts fit discovered one fin's tab is 1/16th longer than the others. Overall it is the same height but when press fit it stands off the BT by 1/16. If I sand to fit the BT the height will be 1/16th shorter than the other two. Would this concern you or should I not worry?
I have sent word to Madcow but not heard back yet.
I have sent word to Madcow but not heard back yet.