Over in the Quinstar thread in the Vendors section I mentioned that I had gotten one as well and was going to post a build thread (including how I recovered from messing it up). Then after a few days John Boren asked me when I was going to get around it. Finally, here we go.
First the obligatory package, then parts spread pictures.
The third shows the five interlocking balsa parts laid out.
Fourth, those same parts but with the motor mount and top cap subassemblies and the body tube (which is BT-50).
Next is a six-picture sequence showing how the big parts start to interlock. At this point there is no glue involved with these parts.
First the obligatory package, then parts spread pictures.
The third shows the five interlocking balsa parts laid out.
Fourth, those same parts but with the motor mount and top cap subassemblies and the body tube (which is BT-50).
Next is a six-picture sequence showing how the big parts start to interlock. At this point there is no glue involved with these parts.