Initiator001
Well-Known Member
- Joined
- Jan 18, 2009
- Messages
- 3,400
- Reaction score
- 1,111
I see that it spins
Nine times out of ten it spins going up one way, stops and begins to descend still right side up, and then spins the opposite way all the way down to the ground. Cleaver people could easily modify it for 24mm motors and then use a 24mm to 18mm motor adapter to fly on B6-0 and C6-0 motors. Or do what I did and fly it on a 18mm composite D10 motor. None of what I just stated is recommended my Estes.
John Boren
Just another modeler
Any idea of when this will be available
Nine times out of ten it spins going up one way, stops and begins to descend still right side up, and then spins the opposite way all the way down to the ground.
I will try to post a build thread soon.
It's been five days, where is the build thread? :cyclops:
John Boren
It is built completely out of 1/16 sheet balsa. It was strong enough for the 18mm D10 motor I tested for the heck of it, but since the model is built to fly on B6-0 and C6-0, I won't promise it will stay together with any other motor.
Enter your email address to join: