- Joined
- Jan 17, 2009
- Messages
- 5,204
- Reaction score
- 1,547
Made up an ID Label to put onto a case for my R/C transmitter. Have flown all of these (OK, so I did not have a good glide photo of my own shuttle orbiters).
To print the ID Label (created in Photoshop), I used an inkjet printer. Then went to Officemax, and had them make a color copy onto glossy paper. The color toner holds up in sunlight over time better than inkjet ink does. Then had it cut out and laminated. To attach it to the Tx case, I used 3M77 spray adhesive on the case, and onto the back of the laminated label.
To print the ID Label (created in Photoshop), I used an inkjet printer. Then went to Officemax, and had them make a color copy onto glossy paper. The color toner holds up in sunlight over time better than inkjet ink does. Then had it cut out and laminated. To attach it to the Tx case, I used 3M77 spray adhesive on the case, and onto the back of the laminated label.