SMR
Entropy Demonstrator
- Joined
- May 15, 2009
- Messages
- 2,134
- Reaction score
- 171
Just back from a family vacation / EF tour of China, and picked up 2 weeks of stopped mail. Mostly bills and junk mail, but one pleasant surprise was the arrival of the fiberglass 2.6" Jayhawk kit from Wildman Rocketry. The kit is well designed, beautifully executed, and everything trial fit perfectly.
What you get...
what you will need...
What you get...
2.6" x 8.5" fiberglass infused polycarbonate nose cone, 3.27 Ogive, slotted for the canards
2.6" fiberglass infused polycarbonate conical tailcone
38mm x 14" fiberglass motor mount tube
2 fiberglass centering rings (mid and forward)
1 plywood centering ring / thrust ring (aft, must be sanded to fit into the inside taper of the tailcone)
2 main wings, 3/32" G10 fiberglass, CNC cut with tabs for winglet attachment
2 winglets, 3/32" G10 fiberglass, CNC cut with slots to match tabs on the main wings
4500 high temperature 2 part epoxy
1-piece fiberglass canard section (contains both canards), slides through nose cone slot
1 fiberglass nose cone bulkhead
2.6" x 22" fiberglass body tube, slotted for the main wings1 fiberglass nose cone bulkhead
2.6" fiberglass infused polycarbonate conical tailcone
38mm x 14" fiberglass motor mount tube
2 fiberglass centering rings (mid and forward)
1 plywood centering ring / thrust ring (aft, must be sanded to fit into the inside taper of the tailcone)
2 main wings, 3/32" G10 fiberglass, CNC cut with tabs for winglet attachment
2 winglets, 3/32" G10 fiberglass, CNC cut with slots to match tabs on the main wings
4500 high temperature 2 part epoxy
what you will need...
rail buttons
recovery harness
parachute
motor retention
paint and decals
recovery harness
parachute
motor retention
paint and decals
Last edited: