Killachrome
Well-Known Member
- Joined
- Aug 1, 2013
- Messages
- 180
- Reaction score
- 0
Hi,
So I'm trying to get my RRC3 ready for our 4H high powered launch in a few weeks. However, I noticed a few this wrong with my RRC3.
1) The tone is low like it doesn't have enough current going through it. I tried multiple wires, connectors and batteries. Also tried various piezo settings, but that only changes the frequency.
2) The RRC3 fails to go into program mode. It just beeps 2 times and then cycles again after a second delay. I only have the battery connect so it should be giving me 3 after a 5 second delay between turn on.
There is no damage or residue on any of the components. Any help from anyone would be most appreciated. Thanks!
So I'm trying to get my RRC3 ready for our 4H high powered launch in a few weeks. However, I noticed a few this wrong with my RRC3.
1) The tone is low like it doesn't have enough current going through it. I tried multiple wires, connectors and batteries. Also tried various piezo settings, but that only changes the frequency.
2) The RRC3 fails to go into program mode. It just beeps 2 times and then cycles again after a second delay. I only have the battery connect so it should be giving me 3 after a 5 second delay between turn on.
There is no damage or residue on any of the components. Any help from anyone would be most appreciated. Thanks!