qquake2k
Captain Low-N-Slow
- Joined
- Jan 26, 2010
- Messages
- 13,574
- Reaction score
- 65
I'm with cody on this one
.............
Maybe heat with a torch gently, and then bend with pliers?
Nate
...Using some of your suggestions, I decided to go for it. I wrapped the hair with a wet paper towel, and used a small butane torch to heat the arms, one at a time. As you can see, I was a bit too aggressive at first...
Hope you have all of your fingers after that...
They are known to remove them with extreme prejudice...:jaw:
In all serious, this just made my day. Thanks for the laugh and head shake, Captain.
In answer to your question, maybe an E.T. doll?
Please tell me this is going to fly at Snow Ranch. My sister was addicted to these trolls when she was little, and would find this hilarious.
I've done some custom mods on figures in the past...I would've suggested holding the arm a proper distance to the side of a candle flame and rotating a bit until the plastic gets soft enough to bend or just cutting a wedge shape section out and regluing.
...or you can get a bigger Troll to twist the little troll's arm!
I grew up on a farm...
We used to cut the heads off chickens...
Trolls should not be a problem...
First, make sure they are thoughly contained...
Then, administer a "tazer to the temple"...
This will buy you about five minutes to complete the desired task...
Be forewarned, when they wake up, they will be pissed...:y:
No matter how hard anyone could try they would never top your wit. Thanks for shedding some light on a dark day!
Why would I need an astronaut Troll doll to fit in a 3" clear acrylic tube, you might ask? Well, what else would I put in an upscale X-Ray? I mean honestly! :tongue:
Im going to have nightmares from viewing this post.
You have a naked Kupi Doll with a bag over its head next to a burning torch!!!
Whats next?
A cordless electric drill?
A pneumatic nail gun?
Oh!! The humanity!!
Enter your email address to join: