I made this 4 wrap carbon tube not too long ago and it just needs to go. To this point I tried to get it looking good, but I dont have any extra epoxy to waste. If you dont mind the extra work to get it looking glossy then this tube is for you.
Laminated with Adtech epoxy, motors fit perfectly and OD is right at 2.23". Again needs I believe at least one more good coat of epoxy, wet sanding, and polish after that to get it looking glossy.
Picture:
I am asking for $60+ shipping, PM if you are interested and paypal is prefered.
Laminated with Adtech epoxy, motors fit perfectly and OD is right at 2.23". Again needs I believe at least one more good coat of epoxy, wet sanding, and polish after that to get it looking glossy.
Picture:
I am asking for $60+ shipping, PM if you are interested and paypal is prefered.