AAA plans ihave been working on ( in progress )

The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I have one of these:
20141128_212110.jpg

The Leading Edge is 3.1 inches

20141128_225147.jpg
 
Ok thanks any other information will be helpful thanks Chris
 
The fins are through the wall .2 inches.
20141128_225339.jpg
 
Thanks for all the information . Will redo the SIM and post it in the morning
 
Directions are sparse:
20141128_230308.jpg

20141128_230316.jpg

20141128_230334.jpg

Note the hand written recommended motors!

20141128_230353.jpg
 
Last edited:
I have not looked at your sim, but the 1650 uses the same Estes pnc as is on the Der Red Max, with the shoulder cut off and a coupler glued in to fit the thick wall tubes.
 
Yes I switched out airframe for the 38mm loc with the loc NC
 
Back
Top