Help Support RocketryForum by donating using the link above or becoming a Supporting Member.


Rockets

Page 1 of 2 1 2 LastLast
  1. My son wanted flames on his Formula 38. Here's a test render.
  2. My son wanted flames on his Formula 38. Here's a test render.
  3. Sophia's first fillets
  4. Sophia's first fillets
  5. Sophia's first fillets
  6. Formula 38 fins
  7. Formula 38 fins
  8. Mouse 38, Formula 38 and another Formula 38 got their motor mounts secured via the forward centering ring. I also installed the rear rail button...
  9. Nosecone sled for Madcow 38mm thin-walled fiberglass nosecones.
  10. Nosecone sled for Madcow 38mm thin-walled fiberglass nosecones.
  11. Mouse 38 dry fit
  12. 29 hour print - finished. It's a bracket to hold EMT tubing & support L extrusion along with a mount for a 1010 rail.
  13. 29 hour print - finished. It's a bracket to hold EMT tubing & support L extrusion along with a mount for a 1010 rail.
  14. Just finished assembling my quick design of a 3d printed case for my Eggfinder Rx LCD and 3S 1500mAh battery (just because I had several extra of...
  15. Go Devil 29 sled parts - Eggfinder Mini, Quark & split 2S 300mAh lipo
  16. Jawstand launch pad rail adapter and blast deflector
  17. Quicksilver on my Jawstand launch pad
  18. Modified Go Devil 29 on my Jawstand launch pad
  19. My Vanish 29 got more polish and wax. It's ready for some serious flying next weekend!
  20. Aligning the nose cone. I used a rocket stand and a drill to make sure the nose cone was aligned right (symmetrical).
  21. Go Devil 29 avionics sled set screw - a single 3-48 screw.
  22. Go Devil 29 3d printed avionics sled design.
  23. Here's the 1010 adapter board in place. I'll drill the 1/4" holes for the bolts to hold the 1010 rail soon.
  24. 2x6 I'm using as a Jawstand to 1010 rail adapter. The notches are 7/8" holes with cuts at 45 degrees. The cut down top & bottom are so that a 1/4" x...
  25. Mobius mount for my Quicksilver
Showing photos 1 to 25 of 44
Page 1 of 2 1 2 LastLast